pellenc Prunion - Putting the Lead and Wrist Strap in Place; Use; Usage Tips

PRUNING SHEARS AND 150 BATTERY VINION & PRUNION
26_116772-H
4.3. PUTTING THE LEAD AND WRIST STRAP IN PLACE
5. USE
5.1. USAGE TIPS
• You must take all necessary care to prevent catching the lead of the pruning shears in the branches. To do this,
attach the lead to your arm using the wrist strap provided. (see page 15 or 17)
• The operating time and service life of the pruning shears mainly depend keeping the blade properly sharpened
and adjusted.
• It is essential to remove the burrs (wire edge) from the cutting edge of the blade, and to file it off within the first
15 minutes of use.
• We recommend that you do not disconnect the lead of the pruning shears from the battery unit after use each
day, but wind it around the "battery" unit and replace them both in their carry-case.
There are various usage modes available to best meet your working practices and to save battery power. The
battery is supplied in the most efficient mode.
• These modes are shown on the display.
• The factory setting for the pruning shears is "performance" mode (U1).
18