IntelliBrite Landscape Light Installation and User’s Guide
The “IntelliBrite” color show set is the default setting. For more information
about selecting the “Landscape” color light shows, see “Light Toggle Switch
Settings” on page 12. The “IntelliBrite” color light shows are described below.
Select an IntelliBrite color light show or fixed color
1. Switch power on to the transformer. The previously selected color or
color show will start.
2. To select one of the IntelliBrite color light shows (1-7) or fixed colors
(8-12), turn the transformer 120 Volt AC power switch OFF and ON a
specific number of times. Each number (1-14) shown below,
corresponds to the number of times to cycle power to activate a color
show or fixed color. 13 and 14 activate the Hold and Recall feature.
OPERATING THE “INTELLIBRITE” COLOR LIGHT SHOWS
3
13 Hold Feature: Capture and save a color effect while
displaying one of the light show effects.
14 Recall Feature: Activate the last saved color effect.
Cycle
Power IntelliBrite Color Light Shows and Fixed Colors
Times
1 SAM mode: Cycles through white, magenta,
blue and green colors. Emulates Pentair Water Pool
and Spa SAm
®
light.
2 Party Mode: Rapid color changing building energy
and excitement.
3 Romance Mode: Slow color transitions creating a
mesmerizing and calming effect.
4 Caribbean Mode: Transitions between a variety of
blues and greens.
5 American Mode: Patriotic red, white and blue
transition.
6 California Sunset Mode: Dramatic transitions of
orange, red and magenta tones.
7 Royal Mode: Richer, deeper color tones.
8 Blue: Fixed color.
9 Green: Fixed color.
10 Red: Fixed color.
11 White: Fixed color.
12 Magenta: Fixed color.
To Next Page
Loading...
Need help?
General
