Pentair INTELLIFLO VSF - Time out Feature P; Quick Clean Feature P

OPERATING THE PUMP 12/25
SET RAMPING RATE
The rate that the drive changes the motor speed can be reduced for smoother operation.
This setting increases or decreases how quickly the pump can ramp up or down between two
speeds. Rates can be set and adjusted for ramping up and ramping down individually.
If the start/stop button is ever pressed, the motor will immediately stop and will not follow
the programmed ramping rate. The default setting is “fast”, which is the traditional IntelliFlo
ramping rate. Medium will take twice as long to change speeds, and slow will take three times
as long.
To set ramping rate:
1. Check that the green power LED is on.
2. Press menu.
3. Press select to select “Settings”.
4. Use the up or down arrow to scroll to “Device” and press select.
5. Use the up or down arrow to scroll to “Ramping” and press select.
6. Use the up or down arrow to scroll to “Ramp Up”. Press select and use the up or down
arrow to choose between “Fast”, “Medium” or “Slow”. Press save.
7. Use the up or down arrow to scroll to “Ramp Down”. Press select and use the up or down
arrow to choose between “Fast”, “Medium” or “Slow”. Press save.
PROGRAMS 1-8 (SCHEDULE A TIME TO RUN THE PUMP)
PUMP OPERATING MODES
The IntelliFlo
®
VSF pump can be programmed in three different modes: manual, schedule
and egg timer. Programs 1-4 can be programmed in all three modes. Programs 5-8 can
only be programmed in schedule mode since there are no buttons on the control panel for
programs 5-8. The default setting for programs 5-8 is disabled.
Set Flow
Manual
Schedule
Egg Timer
Set Speed
Set Type
Set Flow
Set Type
Set Start Time
Set Stop Time
Set Flow
Set Speed
Set Flow
Set Duration
Set Type
Set Flow
Set Speed
Set Flow
Program 1-4
Schedule
Disabled
Default: Disabled
Set Type
Set Start Time
Set Stop Time
Set Flow
Set Speed
Set Flow
Program 5-8
Speed Menu Tree Options
23