User Guide Riversoft
Ref. MKT-UG-045 / A - 13.03.2020 15 / 132
EN
• in any case, any failure caused by improper installation and/or piping connections may void the warranty of Pentair
products;
• in the same way, using lubricant* on the valve thread is not allowed and will void the warranty for the valve and tank. Indeed
using lubricant there will cause the valve to be over-torqued, which may lead to valve thread or tank thread damage even if
the connection to piping has been done following the above procedure.
*Note: Use of petroleum-based grease and mineral based lubricant is totally forbidden, not only on the valve thread, since plastics
(especially Noryl) will highly suffer from contact with this type of grease, leading into structural damage hence to potential failures.
5 . Programming
5.1. Display
1. Digits Two digits used to display the time, program value or error codes.
2. Flow indicator
The flow indicator blinks ON and OFF when water flow turns the meter.
3. Delayed regeneration
indicator
When this dot is displayed, it means that a delayed regeneration is programmed.
Bypass configuration
Manifold configuration
Riversoft_368_604-606_UG_VX_Multilingual.book Page 15 Jeudi, 18. juin 2020 3:38 15
To Next Page
Loading...
