23800 /3614
1 Tv indication dial should be set just
center portion of viewing finder.
2 Tv indication (1000) should be set as
shown in Figure.
3 Three jointing gears (0-M53), (0-M62)
and (0-M74) must function well.If they
do not, adjust the position of Idle gear
supporter plate (M73) with eccentric
screw
A
4 Each figure of Tv indication must come
in the center portion, adjusting eccentric
screw
B
41. Front board plate assembly (A100).
Mechanical back 45.46mm
42. Sv resistor assembly (J300) — (E208)
43. P.C.board assembly (H500)
a.) LED
(A41-01) — W3 — CNM 1.7 x 2.5 — CNL-D 1.4 x 2.5
b.) GPD
(J205) — (J206) — (J208)
c.) Bonding (J500) to Penta prism cover
d.) (J204) — (J209) x 2
44. Soldering lead wires — 7pcs
45. Bottom cover assembly (A400) — CSS 1.7 x 2.2 x 3
Tripod screw (All) — CSM 1.7 x 3.5 x 2
46. Adjustment of LED indication place
To Next Page
Loading...
