23800 /3617
9. Install adjusting plate (E120) and other parts.
Adjusting plate (E120) is installed after
turning Top selector gear and Selector
retainer (0-E118) to cocked position.
10. Install 1
st
curtain string to bobbin (E3).
Confirm curtain overlapping and slit parallel, with adjusting the
length of 1st curtain string.Aron-alpha is applied to curtain string
and its retainer screw (CNS 1.4 x 1.6) after adjustment is finished,
and cut the curtain string after turning around the Bobbin one time
on the other way.
11. Clearance between Bottom selector gear assembly (0-E124) and High speed lever assembly (0-E126)
should be adjusted at 0.1mm with cocked position by turning Adjusting plate (E120).
After adjustment, apply aron-alpha to Retainer screw (E121).
To Next Page
Loading...
