peplink balance ONE - Page 115

USER MANUAL
Peplink Balance Series
http://www.peplink.com -115 / 261 - Copyright © 2015 Peplink
This field is optional. With this field filled, the Peplink Balance will initiate connection to each
of the remote IP addresses until it succeeds in making a connection. If the field is empty,
the Peplink Balance will wait for connection from the remote peer. Therefore, at least one of
the two VPN peers must specify this value. Otherwise, VPN connections cannot be
established.
Click the icon to customize the handshake port (TCP)
Data Port
This field is used to specify a UDP port number for transporting outgoing VPN data. If
Default is selected, UDP port 4500 will be used. Port 32015 will be used if the remote unit
uses Firmware prior to version 5.4 or if port 4500 is unavailable. If Custom is selected,
enter an outgoing port number from 1 to 65535.
Bandwidth
Limit
Define maximum download and upload speed to each individual peer. This functionality
requires the peer to use PepVPN version 4.0.0 or above.
WAN
Smoothing
A
While using PepVPN, utilize multiple WAN links to reduce the impact of packet loss and get
the lowest possible latency at the expense of extra bandwidth consumption. This is suitable
for streaming applications where the average bitrate requirement is much lower than the
WAN's available bandwidth.
Off - Disable WAN Smoothing.
Normal - The total bandwidth consumption will be at most 2x of the original data traffic.
Medium - The total bandwidth consumption will be at most 3x of the original data traffic.
High - The total bandwidth consumption depends on the number of connected active
tunnels.
A
- Advanced feature, please click the button on the top right-hand corner to activate.
To enable Layer 2 Bridging between PepVPN profiles, navigate to Network>LAN>*LAN
Profile Name* and refer to instructions in section 0.