PERCEPT BC100 - Page 14

14
14
support@ionodes.com | www.ionodes.com | 450-696-1060
User operation
User manipulation
User feedback
Status LED
OLED text
Power On
Press power button for ≥3 sec
Flashing* Cyan
Booting
Power Off
Press power button for ≥5 sec
Shutdown…
Change Wi-Fi configuration
Press F2 & F4 simultaneously for ≥5 sec
then scan new QR code containing Wi-Fi access point information
Heartbeat Flashing*** Blue
Scan Network QR
Start/stop continuous
recording
Press F5 for <3 sec to start (when body camera is on)
Press F1 or F3 or F5 for >3 sec to start (when body camera is off)
Press F5 for >5 sec to stop
Heartbeat Flashing*** Red
Cont. Recording
Start event recording (or
tagging an event when in
continuous recording)
Press F1 or F3 for <3 sec
Heartbeat Flashing*** Red
Event Recording
Still image capture
Press F2 or F4 for <3 sec
Snapshot…
Show current battery charge
Press power button for <3 sec and cycle displayed data
Level: (%)
Show SD card status when SD
card detected
Press power button for <3 sec and cycle displayed data
SD Storage
Used (%)
Show SD card status when SD
card is faulty or not detected
Press power button for <3 sec and cycle displayed data
No storage
Show current date and time
Press power button for <3 sec and cycle displayed data
Current date and
time
Show WLAN status
Press power button for <3 sec and cycle displayed data
• Signal: Weak
• Signal: Moderate
• Signal: Good
• Signal: Great
• Signal:
Disconnected
IP address
MAC address
Show cellular status
Press power button for <3 sec and cycle displayed data
• Signal: Weak
• Signal: Moderate