PERCEPT BC100 - Page 15

15
15
support@ionodes.com | www.ionodes.com | 450-696-1060
User operation
User manipulation
User feedback
Status LED
OLED text
• Signal: Good
• Signal: Great
• Signal:
Disconnected
Show Ethernet status****
Press power button for <3 sec and cycle displayed data
• ETH: Connected
• ETH:
Disconnected
IP address
MAC address
Show VPN status
Press power button for <3 sec and cycle displayed data
• Disconnected
• IP address
Show GPS status
Press power button for <3 sec and cycle displayed data
• Signal: Locked
• Signal: Not
Locked
Show Docker status
Press power button for <3 sec and cycle displayed data
• Disconnected
• Auto Online
• Auto Charging
• Man. Online
• Man. Charging
Change Docker mode
Press F1 or F3 for >5 sec while the camera is docked
Docker status
Silent mode on/off
Not defined
Front LED: OFF
Top LED: ON
Privacy mode on/off
Press F1 & F3 simultaneously for >5 sec
Front LED: Steady Orange
Top LED: Flashing* Orange
Privacy Mode
Reset to factory settings
Press F1 & F2 & F3 & F4 simultaneously for >5 sec
Reset config…
Turn flashlight on/off
Press F2 & F4 simultaneously for <5 sec
*flashing: alternating ON for 500ms/ OFF for 500ms
**rapid flashing: alternating ON for 250ms/ OFF for 250ms
***heartbeat flashing: ON for 250ms/ OFF for 250ms/ ON for 250ms/ OFF for 1250ms
****Ethernet status will be available when connecting to the network via the docking station