09931238D
8. Push Manual Button (Stop) and then light goes off.
CAUTION
ATTENTION
If you hear the alarm sound during the operation, push the emergency switch to
stop all functions immediately and check the status of Peltier Controller carefully.
Then, turn the switch to the right again when everything is solved properly and
the functions will be on again.
Si l'alarme se déclenche en cours de fonctionnement, appuyez sur l'interrupteur
d'urgence pour arrêter immédiatement toutes les fonctions et contrôlez
soigneusement l'état du contrôleur Peltier. Ensuite, tournez à nouveau
l'interrupteur vers la droite une fois la situation rétablie afin de restaurer les
fonctions.
Figure 19 Emergency switch
14. Turn off the power after the experiment.
How to drain the coolant from Peltier Controller
a. Push the Air Vent Manual button to be switched on the rear panel of Peltier Controller before
operation.
b. Connect the waste hose to the Coolant Drain port to the rear panel and prepare a waste bucket.
c. Turn on the power of Peltier Controller, and then the coolant will be drained automatically.
d. As draining is completed, turn off the power to the Peltier Controller.
To Next Page
Loading...
Need help?
General
