09931238D
Rear View of Peltier Controller
Figure 8 Rear view of the Peltier Controller
a. RS-232 port
b. AC POWER: Main Power ON/OFF
c. FUSE: AC Socket + Fuse Holder
d. INTERFACE: Interface cable for connecting with Peltier control Single Cell
e. Air Vent Manual switch: Used for removing the air in the coolant hose.
f. Buzzer: It makes an alarm sound. If there is any problem before the measurement, the buzzer
beeps 6 times every 10 sec. If the malfunction occurs during the operation, the buzzer beeps
twice every 10 sec.
g. Quick Coupler of Coolant lnlet/Outlet
h. Quick Coupler of Coolant Drain
i. N
2
Gas Inlet/Outlet ports
NOTE:
N
2
gas is not always required [Tube for N
2
gas is not supplied with the accessory].
j. Flow Gauge: Indicator of the flow rate of N
2
gas.
To Next Page
Loading...
