UV Lab Software. 45
▶ Stabilizing Time (sec)
To make stabilization after the blank or sample solution is filled up the cell, enter
the suitable stabilizing time. If the time is set as '0', it will be scanned directly
without the stabilization.
▶ Washing Time After Sampling (sec)
To clean the tube & flow cell after the measurement, you need to set the
washing time.
▶ Download: After all set-up, Click Download before measurement.
▶ Run: Click Run to check if the peristaltic pump is working as set.
▶ Stop: Stop the Run test of peristaltic pump.
6. Click Download after setting the parameter and then the following box appears.
Click OK.
NOTE:
Click Download again when the parameter is changed or COM Port No. is set newly.
7. Click OK.
To Next Page
Loading...
Need help?
General
