SEBU8337 69
Maintenance Section
Engine Oil and Filter - Change
g01394084
Illustration 36
4. Install the filter element into the filter bowl. Ensure
that the insert (3) on the oil filter aligns to the
square (4) in the filter bowl.
g01394093
Illustration 37
Typical example
NOTICE
Do not fill the oi
l filters with oil before installing them.
This oil would not be filtered and could be contaminat-
ed. Contaminated oil can cause accelerated wear to
engine compon
ents.
5. Install the O ring seal (5). Lubricate the threads on
the filter bowl
with CV60889 Special Lubricant.
6. Install the filter bowl and the element. Tighten the
filter bowl (1)
toatorqueof90N·m(66lbft).
7. Install the drain plug (2) and tighten to 1.2 N·m
(11 lb in).
Fill the Engi
ne Crankcase
1. Remove the oil filler cap. Refill the engine
crankcase wi
th engine oil. Refer to the Operation
and Maintenance Manual, “Refill Capacities ”
and Operation and Maintenance Manual, “Fluid
recommenda
tions” for more information.
NOTICE
If equipped with an auxiliary oil filter system or a re-
mote oil filter system, follow the OEM or filter manu-
facturer’s
recommendations. Under filling or o verfilling
the crankcase with oil can cause engine damage.
NOTICE
To prevent crankshaft bearing damage, crank the en-
gine with the fuel OFF. This will fill the oil filters before
starting the engine. Do not crank the engine for more
than 30 seconds.
2. Start the engine and run the engine for two
minutes. Perform this procedure in order to ensure
that the lubrication system has oil and that the oil
filters are filled. Inspect the oil filter for oil leaks.
3. Stop the engine and allow the oil to drain back to
thesumpforaminimumoftenminutes.
4. Remove the oil level gauge in order to check the
oil level. Maintain the oil level between the “Low”
and “High” marks on the oil level gauge.
To Next Page
Loading...
