EasyManua.ls Logo

Pfaff 114 User Manual

Pfaff 114
36 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
Instruction Manual
114
296-12-18 613/002
Betriebsanleitung engl. 12.04
This instruction manual applies to machines from the
following serial numbers onwards:
# 6 001 000

Table of Contents

Question and Answer IconNeed help?

Do you have a question about the Pfaff 114 and is the answer not in the manual?

Pfaff 114 Specifications

General IconGeneral
BrandPfaff
Model114
CategorySewing Machine
LanguageEnglish

Summary

Safety

General notes on safety

Machine operation by trained operators only. Read manual. Follow safety instructions. Disconnect power for tool changes, threading, and maintenance.

Safety symbols

Explains danger and caution symbols related to machine operation and personnel safety.

Important points for the user

Manual is integral part. Read before first use. Instruct personnel on safety. Operate in perfect running order. Ensure safety mechanisms are not deactivated.

Operating personnel

Persons responsible for operation. Must observe safety notes, wear appropriate clothing, and report safety issues.

Specialist personnel

Persons with specialist education for maintenance and repair. Must observe safety notes, switch off power, and replace coverings.

Danger

Specifies safety distances and hazards like needle injury, trapped objects, and belt hazards.

Proper use

Specifications

Controls

On/off switch

Switch the machine on or off by turning main switch 1.

Pedal

Indicates machine stop (0) and sew (1) positions for the pedal.

Presser foot lift lever

The presser foot is raised by raising lever 1.

Installation and commissioning

Installation

Machine installation by qualified personnel. Observe safety regulations. Use a sturdy stand. Ensure firm, horizontal surface and sufficient lighting.

Commissioning

Examine machine for damage. Clean and oil before commissioning. Connect only to earthed socket. Check voltage and connection. Balance wheel must turn towards operator.

Preparation

Threading the bobbin case / adjusting the bobbin thread tension

Insert bobbin 1, pass thread through slit, hole, and eye 4. Adjust tension with screw 5. Bobbin must turn correctly.

Threading the needle thread / Adjusting the needle thread tension

Switch off machine. Thread needle as shown in Fig. 9-05. Adjust needle thread tension with screw 1.

Care and maintenance

Wearing parts

Related product manuals