27
Setting up
Place an empty bobbin 1 onto bobbin shaft 2.
Thread the bobbin in accordance with Fig. 9-02 and wind it anti-clockwise around bobbin
1 a few times.
S
witc
h on the bobbin winder while at the same time pressing bobbin winder spindle 2
and lev
er 3.
The bobbin fills up during sewing.
The tension of the thread on bobbin 1 can be adjusted with knurled screw 4.
The bobbin winder stops automatically when bobbin 1
is full.
Remo
ve the filled bobbin 1 and cut the thread on knife 5.
If the thread is wound une
venly, loosen nut 6 and turn thread guide 7 accordin-
gly. R
etighten nut 6 after the adjustment.
●
●
●
●
●
●
Fig. 9 - 02
1
2
3
4
5
6
7
9.02 Winding the bobbin thread, adjusting the thread tension
To Next Page
Loading...
