35
STRAIGHT STITCHES AND NEEDLE POSITION
Changing the needle position
These setting apply only to patterns 01-05. The pre-set
position is “3.5”, center position. When you press the “-“
stitch width adjustment button, the needle position will
move to the left. When you press the “+” stitch width
adjustment button, the needle position will move to the
right. On the LCD screen, the point illustration and the
number indicate the needle position.
Changing the stitch length
To shorten the stitch length, press the “-“ stitch length
adjustment button. For a longer stitch length, press the
“+” stitch length adjustment button.
Generally speaking, the thicker the fabric, thread and
needle, the longer the stitch should be.
ZIGZAG STITCHES
Adjusting the stitch width
The maximum zigzag stitch width for zigzag stitching
is “7.0”; however, the width can be reduced on any
patterns. The width increases as you press the “+” stitch
width adjustment button from “0.0-7.0”.
Adjusting the stitch length
The density of zigzag stitches increase as the setting of
stitch length approaches “0.2”.
Most zigzag stitches are sewn at “1.0-2.5”.
Dense zigzag stitches (close together) are referred to as
a satin stitch.
To Next Page
Loading...
Need help?
General
