ENG
Operating Manual | Attachment and Installation Cooling Units | Standard Controller (SC) – 230 V | 086100113 54/66
Assembling the unit cover
Prerequisite
DANGER – Danger to life due to electric shock. Make sure that the
unit is voltage-free.
Wait for a discharge phase of 10 minutes for the electrical components.
The unit should only be opened afterwards.
Procedure
1. Plug the earthing cable (3) into the inside of the unit cover (2).
2. Push the lugs (4) of the unit cover into the slits (5) in the floor plate.
3. Plug the earthing cable (3) into the inside of the unit cover.
4. Close the unit cover again.
ATTENTION – Damage to the unit.
When closing the unit cover, make sure that the earthing cable (3) is
not trapped.
5. Fasten the unit cover with the four screws (1).
The unit cover is assembled.
Fig. 24: Assembling the unit cover
To Next Page
Loading...
