PG DRIVES TECHNOLOGY S-DRIVE – APPENDIX - A
SK76745/10
14.1 Reversed battery polarity
S-Drive products meet the reversed battery polarity requirement.
14.2 Integrity of enclosures
S-Drive products should not be installed in locations where they would be at risk of impact with static external structures. Hence
this requirement does not apply.
15.1 Information general
PGDT provides all relevant information to use and install S-Drive products safely.
15.2 Wiring diagram
This sub-clause does not apply to S-Drive products. In particular, they have no user-serviceable circuit protection components.
15.3 Operating instructions
PGDT provides all relevant information to operate S-Drive products safely.
15.4 Safety information
PGDT provides information on interpretation of the battery gauge, and can provide additional guidance on the cause and
effects of electromagnetic interference if needed. Other requirements in this sub-clause do not apply to S-Drive products.
15.5 Removable parts
S-Drive products have no removable parts.
15.6 Residual risks
PGDT provides information on residual risks. The primary one is the risk due to sudden stopping in the event of a fault, which is
accepted by the standard and included in the list specified in 15.4.
16 Test report
Not applicable to S-Drive products.
17 Disclosure
Not applicable to S-Drive products.
To Next Page
Loading...
