PhaseOne iXG - Mounting a Lens on the Ixg Camera; 4 Connecting Peripherals; Attaching the Camera to a Copy Stand

1110
Mounting a Lens on the iXG
Camera
Lenses of the iXG cameras are easily mounted.
Note:
• Ensure that you only mount lenses in a clean environment.
• Place a soft cloth down on the table to avoid scratching the lens.
• Ensure that you remove the rear lens cap (if attached)
before mounting the lens.
To Mount a lens:
1. Place the Lens over the iXG camera body and guide it
into position against the camera body using the two large
positioning pins.
2. Close the Lens locking levers.
Note: The Lens is a-symetrical, and can only be fitted in ONE
position.
4. Connecting Peripherals
This section describes the dierent peripheral devices, which
can optionally be connected to the iXG camera.
Attaching the iXG camera to a copy stand
1. If not already attached, use the supplied 4mm Allen
screwdriver to attach the L-bracket to the iXG camera by
its two (hidden) screws.
Two Positioning
Pins
Hidden Screws
L Bracket
Lens Locking
Lever