PhaseOne iXG - Connecting Flash Sync Cable; Connecting the Power Supply

1716
Connecting Flash Sync Cable
The Flash Sync Cable is used to trigger a Flash device (a
generator or a wireless transmitter).
To connect the Flash sync cable:
1. Connect the Lemo connector of the Flash sync cable to
one of iXG camera’s data terminnals.
2. Connect the cable’s other end (Audio connector) to the
Flash device.
Power
Input
Power
Supply
Audio ConnectorLEMO Connector
Connecting the Power Supply
To connect the camera to the iXG power supply:
• Connect the Lemo connector of the iXG power cable to the
power terminal of the iXG camera.
Note: When not in use, always disconnect the power from the
iXG camera.