1514
Camera Remote Triggering
The iXG camera can be triggered by the following options:
• Remote Shutter Trigger
• Foot Pedal
Connecting the Remote Shutter Trigger
The Remote Shutter Trigger is used to remotely trigger the
iXG camera. Use the 5-meter trigger cable to connect the
Hand release trigger with 30cm cable to the iXG camera.
To connect the Remote Shutter Trigger:
1. Connect the LEMO-of the iXG 5 meter trigger cable to one
of the data terminals of the iXG camera.
2. Connect the 30 cm cable to the Hand Release Trigger
3. Connect the other end (female Audio connector) of the
iXG Hand Release Trigger cable to the 3.5 mm male audio
jack of the 30 cm cable.
Connecting a Foot Pedal
The Foot pedal is used to remotely trigger the iXG camera.
Use the 5 meter trigger cable to connect a Foot pedal unit to
the iXG camera
To Connect a iXG Foot Pedal:
1. Connect the LEMO-of the iXG trigger cable to one of the
data terminals of the iXG camera.
2. Connect the other end (female Audio Connector) of the
iXG hand release trigger cable to the 3.5 mm male audio
jack of the foot pedal.
LEMO
Connector
Power Input
iXG 5-Meter
Trigger Cable
30cm Cable
Female
Connector
Data
Terminals
Hand Release
Trigger
To Next Page
Loading...
