www.phicomm.com
c) Bridge mode
Network Name (SSID): Enter a value of up to 32 characters. This is the wireless network name of
your main AP.
Channel: The router can choose the best channel automatically in most cases. Please try to
change the wireless channel if you notice interference problems with another nearby access
point, or the wireless performance is not as good as you expected.
Wireless Mode: If all of the wireless devices connected with this wireless router are in the same
transmission mode (e.g. 802.11b), you can choose "Only" mode (e.g. 11b only). If you have some
devices which use a different transmission mode, choose the appropriate "Mixed" mode.
Channel Bandwidth: The bandwidth of the wireless channel, you can select 20MHz or
20/40MHz.
SSID Broadcast: If you choose Enabled, the wireless router will broadcast its name (SSID).
Bridge’s SSID: The SSID of the other AP/router you want to be bridged with.
Bridge’s BSSID: The physical address of the other AP/router you want to be bridged with.
Security Mode/Encryption Type: Choose the security mode and encryption type according to
the wireless network you’d like to connect, and enter the password. Click Next to apply the
settings.
To Next Page
Loading...
Need help?
General
