Philips 22HFL4372D/10 - Smart Clone; RF Download

(
36 EN
SmartClone
Place a USB Memory stick in the USBside I/O
connector
Layer 1Layer 2Layer 3
SmartCloneUSBto TVOKor >
TV will read and store Cloning data from USB
stick
Layer 1Layer 2Layer 3
SmartCloneTV toUSBOKor >
TV will store Cloning data to USB stick
RF Download
Instead of using USB memory device to do
cloning (tbd) and firmware update, this
upgrading is also possible using the RF
infrastructure. This is covered by Philips
Hospitality RF Download and allows a
simultaneous upgrade of all installed
televisions.
[SW Types]
Defining the software parts to be upgraded:
[SSB Firmware]
TV Firmware
[SSB NVM]
TV settings
[StandBy Firmware]
Firmware for the StandBy CPU
[ThemeTV]
Supporting files for ThemeTV:
-R1.png–R15.png
-R1s.png–R15s.png
-Background.png
-Header.png
-Footer.png
[All]
All of above
[Program Info]
This function is to set the necessary DVB
parameters to locate the proper VSecure RF
channel to load the VSecureRF Static or RF
Dynamic key(s):
[Frequency]Frequency of MUX
0706)
[Medium]Cable or Antenna (DVB T/C)
[Service ID]# # # # # (00001)
[ONID]# # # # # (00001)
[NID]# # # # # (00001)
[TSID]# # # # # (00001)
[Symbol Rate]# . # # # (6.900)
[Modulation]QAM16, QAM32, QAM64,
QAM128, QAM256
Above parameters must match head-end configuration
[Program Info]
To initiate RFDownload just press OK or >.