Philips 22HFL4372D/10 - 9 Troubleshooting; General TV issues; TV channel issues; Picture issues

44 EN
TVchannelissues
Previouslyinstalledchannelsdonotappearin
thechannellist:
• Check that the correct channel list is
selected.
Nodigitalchannelswerefoundduringthe
installation:
• Check that the TV supports DVB-T or
DVB-C in your country. See the listed
countries on the back of the TV.
Pictureissues
TheTVison,butthereisnopicture:
• Check that the antenna is properly
connected to the TV.
• Check that the correct device is selected
as the TV source.
Thereissoundbutnopicture:
• Check that the picture settings are
correctly set.
ThereispoorTVreceptionfromanantenna
connection:
• Check that the antenna is properly
connected to the TV.
• Loudspeakers, unearthed audio devices,
neon lights, high buildings and other large
objects can inuence reception quality.
If possible, try to improve the reception
quality by changing the antenna direction
or moving devices away from the TV.
• If reception on only one channel is poor,
ne tune this channel.
Thereispoorpicturequalityfromconnected
devices:
• Check that the devices are connected
properly.
• Check that the picture settings are
correctly set.
TheTVdidnotsaveyourpicturesettings:
• Check that the TV location is set to the
home setting. This mode offers you the
exibility to change and save settings.
9 Troubleshooting
This section describes commonly encountered
issues and accompanying solutions.
GeneralTVissues
TheTVdoesnotswitchon:
• Disconnect the power cable from the
power outlet. Wait for one minute then
reconnect it.
• Check that the power cable is securely
connected.
Theremotecontrolisnotworkingproperly:
• Check that the remote control are
correctly inserted according to the +/-
orientation.
• Replace the remote control batteries if
they are at or weak.
• Clean the remote control and TV sensor
lens.
ThestandbylightontheTVblinksred:
• Disconnect the power cable from the
power outlet. Wait until the TV cools
down before reconnecting the power
cable. If the blinking reoccurs, contact
Philips Consumer Care.
YouforgotthecodetounlocktheTVlock
feature
• Enter ‘8888’.
TheTVmenuisinthewronglanguage.
• Change the TV menu to your preferred
language.
WhenturningtheTVon/offtostandby,you
hearacreakingsoundfromtheTVchassis:
• No action is required. The creaking sound
is normal expansion and contraction of
the TV as it cools down and warms up.
This does not impact performance.
WhenTVstart-uptimeisslow:
• Select [Fast] mode in [Lowpower
standby] menu.