Philips 22HFL4372D/10 - Use Scenea; Activate Scenea; Universal access; Enable universal access

18 EN
Note
•
If the sleep timer is off, the wallpaper is
displayed for 240 minutes. Otherwise, it is
displayed for the duration of the sleeptimer.
For more information on the sleeptimer, see
Use more of your TV > Use timers and locks >
Sleeptimer (Page 24).
SetapictureasScenea
Note
•
The le size of the picture must not be
more than 1 MB.
1.
Connect the USB storage device to the
TV.
2.
Press .
3.
Select [BrowseUSB], then press OK.
4.
Select a picture, then press .
5.
Select [SetasScenea], then press OK.
6.
Select [Yes], then press OK.
7.
Press any key to exit Scenea.
Universalaccess
Enableuniversalaccess
Where supported by your digital TV
broadcaster, this TV allows special audio and
subtitles for the hearing impaired, as well
as special audio for the visually impaired.
To enable these features, you must turn on
universal access in the [Preferences]menu.
1.
Press .
2.
Select [Setup] >[TVsettings] >
[Preferences] > [Universalaccess] >
[On], then press OK.
• [Stop]: Stops playback.
• [Repeat]: Repeats a video.
• [Shufeon]/[Shufeoff]: Enables or
disables random play of videos.
Listentodigitalradio
If digital broadcasting is available, digital radio
channels are installed automatically during
installation.
1.
While watching TV, press a.
2.
Select[Channellist:], then press OK.
3.
In the channel list, press .
4.
Select[Selectlist] > [Radio], then press
OK.
5.
Select a radio channel, then press OK.
You can listen to satellite radio broadcast (if
available).
1.
While watching TV, press a.
2.
Select [Channellist], then press OK.
3.
In the channel list, press .
4.
Select [TV/Radio] > [Radio], then press
OK.
UseScenea
ActivateScenea
You can use Scenea to display a picture as
wallpaper on your TV. Make sure that the
location of your TV is set to [Home] mode.
1.
Press .
2.
Select[Scenea] , then pressOK. The
default or pre-loaded picture is displayed.