Philips 22HFL4372D/10 - Install channels; Automatic install; Select audio language; Select video stream (for DVB-S channel only)

23
English
EN
Ifyoudonotwantthismessagetoappear
1.
Press .
2.
Select [Setup] > [Channelsettings]
or [Satellitesettings] >[Channel
installation] > [Channelupdatemessage]
> [Off], then press OK.
• To disable automatic updates In the
[Channelinstallation] menu, select
[Automaticchannelupdate] > [Off].
Selectaudiolanguage
If the TV channel has multiple or dual sound
broadcast, you can select the preferred audio
language.
1.
While watching TV, press .
• [Audiolanguage] : Select the audio
language for digital channels.
• [DualI-II] : Select the audio language
foranalogue channels.
Selectvideostream(forDVB-S
channelonly)
If available, you can view different video
stream of the channel. (depending on
broadcast service provider).
1.
Press .
2.
Select [Videoselection]to view the
various selections.
Installchannels
Automaticinstall
When the TV was switched on for the
rst time, a full installation of channels was
performed. You can redo this full installation
again to set your language, country and install
all available TV channels.
Note
•
[Searchforsatellite] is only available if the TV
supports DVB-S.
1.
Press .
2.
Select [Setup] > [Searchforchannels] or
[Searchforsatellite], then press OK.
3.
Follow the on-screen instructions to
complete the channel installation.
4.
Once complete, select[Finish], then
press OK.
Tip
•
Press
a
to see the channel list.
Note
•
During installation, leave [Settings] unchanged
unless your digital provider provides you with the
specic values to enter.
•
When digital TV channels are found, the list of
installed channels may display empty channel
numbers. You can rename, reorder or uninstall
these channels.
AccessDVB-CorDVB-Tchannels
If you have installed both DVB-C and DVB-T
channels, you have to switch to the respective
network to watch channels on that network.
1.
While watching TV, press
2. Select [Setup] > [Channelsettings].
3. Select [Channelinstallation] > [Antenna
orCableDVB].