Philips 22HFL4372D/10 - Connect a computer; Use a Conditional Access Module; Insert and activate a CAM

40 EN
• DVI-HDMIcable

• HDMIcableandHDMI-DVIadaptor

• VGAcable

DVI
LEFT / RIGHT
HDMI 1 / DVI
AUDIO IN :
PC IN(AUDIO)
For TV of size 26 inch and larger
For TV of size 22 inch
DVI
LEFT / RIGHT
HDMI 1 / DVI
AUDIO IN :
PC IN(AUDIO)
For TV of size 26 inch and larger
For TV of size 22 inch
VGA
VGA
PC IN(AUDIO)
For TV of size 22 inch only
UseaConditionalAccess
Module
A Conditional Access Module (CAM) is
provided by digital TV service operators to
decode digital TV channels.
Note
• If required, refer to documentation from your
operator on how to insert a smart card into the
Conditional Access Module.
InsertandactivateaCAM
Caution
• Be sure to follow the instructions described
below. Wrong insertion of a CAM may damage
both the CAM and your TV.
1. Switch off the TV.
2. Following the directions printed on the
CAM, gently insert the CAM into the
COMMONINTERFACE at the side of
the TV.

3. Push the CAM in as far as it will go.
4. Turn on the TV and wait for the CAM
to be activated. This may take several
minutes. Do not remove the CAM from
the slot when in use — removing the
CAM will deactivate digital services.