EPG Usage
EPG is the electronic program guide provided
on digital channels.With EPG, you can
View the list of the currently broadcast
digital programs.
Watch the current transmitted program.
Set up program reminder.
Turn on EPG (Program Guide)
Press the
TV GUIDE
key on the remote control
to display the program list.
Note
EPG cannot be turned on directly in
non-digital TV mode.
Press the green key in the program
guide to remind or cancel the program to
be played within one week.
Press the red key to turn on the
scheduled recording function: Automatic
or manual is available. According to your
preference, you can manually set recording
time and mode.
Press the yellow key to display the
program information on different dates.
Press the blue key to display the help
instructions.
Recording Menu
Note
Make sure that the USB storage device has
been well connected.
When parental control is activated,
schedule recording may not be able to
function properly.
Program recording
In digital TV mode, press key to recorder
menu on the screen and start program
recording. Press key to exit program
recording. Press
REC LIST
key to display Record
List menu. Press ▲/▼ key to select the
recorded file in record list, and press OK key to
play.You can press keys such as ， ， to
carry out shortcut operation.
Use Philips EasyLink
With
Philips EasyLink
you can operate a
connected device with the TV remote control.
EasyLink uses HDMI CEC (Consumer
Electronics Control) to communicate with the
connected devices. Devices must support
HDMI CEC and must be connected with an
HDMI
connection.
To enable Philips EasyLink, you need to:
Compatible device can work normally.
Switch to EasyLink.
Note
The EasyLink compatible device must be
turned on and selected as a source.
Philips doesn’t ensure 100%
interoperability with all HDMI-CEC
devices.
Turn on or off EasyLink
Note
Do not enable Philips EasyLink if you
don’t intend to use it.
1. Press key.
2. SelectTV Settings > EasyLink > EasyLink.
3. Select OFF or ON and then press
OK
key.
Set HDMI-Audio Output
1. Press key.
2. SelectTV Settings > EasyLink > HDMI –
Audio Out.
3. Select OFF or ON and then press
OK
key.
To Next Page
Loading...
