When the button is in position 10 "-12" (25-30cm), the changer is suitable for playing discs of those
diameters.
Plays with this diameter can be played in position 7 "(17.5 cm)
Control KNOB C: This allows the machine to be started and stopped.
REJECT>>START>>> STOP >>> FWD >>>
1.Element/ Socket with double needle (AG3005). By the unit
The "M" can be placed in front of the stripe on the arm, in which case the unit is set for playing
micro-grove discs, if the pick-up head is turned to N, then plates with normal groove can be used.
2. Sensor head with single needle. This head can be compared to
the pick-up arm only occupy one position. Here it depends on the type used, which discs can be played
with this (see overview of sensor heads under Chapter I).
PALPE/Taster/feeler/probe E:
[ ... ’E ‘ remains LATCHED until a disc/record is ready to drop [“CHANGE”...]
When a 30 cm plate is placed on the turntable from the shoulder of the center pin, the
palp/probe/feeler /taster is pushed backwards [the taster finger near the control disc teeth pivots
upwards towards the P U ARM]. As a result, the mechanism for the horizontal movement of the sensor
is controlled, so that the needle
in the inlet/first groove of this plate.
The plate printer/platendrukker item 62 fig 8 F:
This part performs two functions, namely
1. Keep the plates horizontal, which is at the center pin,
2. To automatically switch off the disc changer at the ending of the last record.
From the above it appears that the position of A, B and D depends on the plates to be played, so that
this must be taken into account. [where is D ?..there is a D on fig 8
p5a
After the plates to be played have been placed on the shoulder of the center pin and the plate press has
been pushed over the center pin, the record changer is ready for use.
12
To Next Page
Loading...
