Philips AG1000 - P6 A; Operation of the Record;Disc Changer

P6a
9. The pick-up arm may always be moved manually when it is once on the plate, for example to repeat a
particular passage. Do not touch the arm when it is moved automatically!
10. When the mechanism comes into operation (either by 'start’ or ' reject 'or at the end of the
DISC) then there is always a next disc.. If you want to hear the same record/disc again after  3
and 5,[ 3. By moving the control knob to the "off" position, the
unit is in the OFF stopped at the end of the drive. ... 5. By pulling the control button forward
while a disc is moving and then returning the button to its stop position, the disc changer stops
immediately.]
 The repeat button must be used. In addition, the repeat button can be prevented from being skipped
when the operation is carried out under maneuvers 3 on 5[see above] and then restarted.
11. The disc changer  is fool-proof on the understanding that extra attention must be paid to the
position of the P.U.unit in connection with the type of grove of the disc.
...................................................................................
VI. Operation of the record/disc changer. TRAINING
The rotating motor is floating through the intermediate wheel [43]
the turntable (65) touched. The intermediate wheel can be moved along the axis of the motor shaft
with the speed operation knob (A fig.3).
left screw A/78 middlescrew C/45 right screw B/33-1/3
15