6. Different female heads for oversee available heads, ...
SEE Chapter I, p. 2.
........................ supply freq motor shaft stepped pulley .......................
AG1000-01 AG1000-02 and -00
-00 220/110 Volt 50 Hz
-01 220/110 Volt 60 Hz p/n 49 938 17.0 pulley similar to this...
-02 220/110 Volt 40 Hz [rare... pre-1925 ..later in some regions]
4 step shown [AG1000 uses 3 speed/step A/B/C ]
Shaft I.D. 3.95mm [ 5/32”]
Shaft O.D. butt= 7.90mm [ 5/16”]
O.D. mm ...as found... ..... after shaving 20% off each A/B/C
33-1/3 Tip A 2.91 2.328
45rpm step B 3.72 2.976
78 rpm step C 6.04 4.832
Example only (poles unknown)
Motor rpm= [120 x f] /p=120x50/4=1500
120x60 /4=1800
1500/1800=1.2 is adapter diameter factor
................................................................................................................
Dimensions:
The dimensions of the mounting plate are 365 x 320 MM . The max. Height of the mounting plate is
130mm , and below the mounting plate is 70 mm.
Consumption: 8 watt
Weight: 5 kg
• This documentation covers the following topics:
I. The transducer/pickups heads, which can be used with this disc changer P4
4
To Next Page
Loading...
