Note: the above picture of the changer ,after red flocking I applied over original factory
brown/tan colour
2. The changer stops automatically after the end of the last record
…… automatically off. The disc changer stops automatically after you have skipped the last disc.
THE DISC CHANGER , AUTOMATICALLY STOPPED AFTER PASSING THE LAST DISC
3. By placing the control knob in the "stop" position, the
the changer is automatically switched off
after the ending of the currently playing record.
4. By pulling/PLACING the control knob forward at a moment when a plate is being played, the
mechanism comes into operation; the plate is interrupted and replaced by the next record, which is
played again from the beginning (reject).
5. By pulling/placing the control knob >>forwards at a moment when a plate is being played and then
placing/positioning the knob into the stop position, the changer is immediately stopped.
P5b
6. Each 25 cm and 17.5 cm disc can be repeated. When
rehearsing 30 cm discs, the pickup fits well on the disc, but
2.5 cm inwards. For repeating a disc, the Repeat button must be
pressed during playback of the disc in question. One can also
repeat a partially reproduced disc. For this you must first
press the repeat button and then start, the repeat button
returns
automatically to its old position.
7. With the help of the supplied short pin, the plate wiping [ my short pin is missing]
be used as A TURNTABLE with automatic switch-off after the end of the record. While the control knob
is in the rest position, the arm (95) is brought onto the plate by hand. After this the button must be
placed in the "stop" position. The RECORD PLAYER is turned aside
8. Continuously repeating a 25 cm (10 ") and a 17.5 cm (7")
DISC is possible in the following way:
Raise the plate presses/platendrukker and turn them aside. The control button must remain in the rest
position after starting and the DISC will be repeated continuously, without using the repeat button.
14
To Next Page
Loading...
