II
The needle does not end up in the inlet groove of a 30CM disc.
.................
690/5000
II Place a 30cm plate on the turntable and place the change pin [centering pin] in the turntable.
Pull / POSITION the starter handle forward and turn the turntable by hand to the right until the upper
part of the change pin starts moving and the P U Arm starts to move inwards, after which the push
button [next to the foot of the P U Arm] is pushed backwards.
The screw bolt [1] is loosened beforehand, after which the P U Arm [which now occupies a
horizontal position] is first turned outwards until it is against the starting handle.
43
To Next Page
Loading...
