32
Note
The preset PIN is 0000. No change can be •
made on it.
Unregister the handsets
1
If two handsets share the same base
stations, you can unregister a handset
with another handset.
2 Press menu.
3 Select [ADVANCED SET] >
[UNREGISTER], then press [OK] to
confirm.
4 Select the handset number to be
unregistered.
5 Press [OK] to confirm.
The handset is unregistered. »
Tip
The handset number displays beside the •
handset name in standby mode.
Restore default settings
You can reset your phone settings to the
original factory settings.
1 Press menu.
2 Select [ADVANCED SET] > [RESET],
then press [OK] to confirm.
The handset displays a confirmation »
request.
3 Press [OK] to confirm.
All settings are reset. »
The welcome screen displays. »
Tip
For more information about the default •
settings, see the section on Default settings.
13 Advanced
settings
Register the handsets
You can register additional handsets to the base
station. The base station can register up to 5
handsets.
Auto registration
1 Place the handset on the base station.
The handset detects the base station »
and start to register automatically.
Registration is completed in less than 2 »
minutes. The base station automatically
assigns a handset number to the
handset.
Manual registration
If auto registration fails, register your handset
manually to the base station.
1 Press menu on the handset.
2 Select [ADVANCED SET] >
[REGISTER], then press [OK] to confirm.
3 Press and hold on the base station for
5 seconds until you hear a confirmation
beep.
4 Enter the system PIN. Press [BACK] to
make corrections.
5 Press [OK] to confirm the PIN.
Registration is completed in less than 2 »
minutes. The base automatically assigns
a handset number to the handset.
Note
If the PIN is incorrect or no base is found •
within a certain period, your handset displays
a notification message. Repeat the above
procedure if registration fails.
EN
To Next Page
Loading...
