Making a recording
Press MONITOR to display the selected input signal on the
screen
Select the program number from which the recording is to be
carried out using CHANNEL+ or CHANNEL-- .
Recording via the external jacks
Select either the front jack ('[F_'¢ f, '[F_M_') or the jack ('EXTI', 'EXTZ,')
at the back of the recorder, from which the recording is to be carried
out, using CHANNEL+ or CHANNEL--.
Selecting the recording mode (quality)
You can select bet_veen 'MI' (camcorder recordingsll hour), 'M2' (2
hours), 'M2x _ (2,5 hours), 'M_ (3 hours), 'M4' (4 hours) or 'M_ (6
hours) using REC MODE.
SAFE RECORD
Usually, a recording starts at the point where the previous recording
ended. This will delete all subsequent recordings.
If a new recording is to be placed at the end of all recordings, hold
down REC/OTR • until 'SF_PEfi_EC' appears on the display.
Tip
Press RECORD or REC/OTR • to start the recording.
[x'Nu n (no signal) appear on display
5_SdRL' will the
¢" Check whether the cable jacks fit correctly.
¢" If the recording is made from a video recorder, adjust the 'tracking
setting on the video recorder.
¢" In case of bad, non-standard video input signals, the DVD Recorder Problem
may not be able to detect the signal.
Programming recordings
3
4
5
6
7
Press TIMERQ on the remote control.
Select line 'Timer Programming' using • or • and confirm
with •,
The current data will be displayed,
Select the entry field with • or • ,
Enter the desired data with •, • or the number buttons
0..9.
Confirm with OK.
The data was stored in a TIMER block,
To end, press TIMER C).
Switch offthe DVD Recorder with STANDBY_.
A programmed recording will only function if the DVD Recorder
is switched off using STANDBYO.
Timer
Timer Programming
Rec
Date Ch. Start End Mode
01/22 01 O8:3fiAM 10:0OPM M1
Mo-Fr/Weekly To store
Press SELECT Press OK
To Next Page
Loading...
