Philips FW-C380 - Rear Connections; AM Loop Antenna Connection; FM Wire Antenna Connection; AC Power Supply

2-2
7
English
General Information
¶ The type plate (which contains the serial
number) is located at the rear of the player.
¶ Recording is permissible if copyright or
other rights of third parties are not infringed.
¶ This product complies with the radio
interference requirements of the European Community.
Environmental Information All unnecessary packaging has been omitted. We have tried to make the packaging easy to separate into three materials: cardboard (box), polystyrene foam (buffer) and polyethylene (bags, protective foam sheet). Your system consists of materials which can be recycled and reused if disassembled by a specialized company. Please observe the local regulations regarding the disposal of packaging materials, exhausted batteries and old equipment.
Energy Star
As an ENERGY STAR
R
Partner; Philips has
determined that this product meets the ENERGY STAR
R
guidelines for energy efficiency.
Supplied Accessories
– Remote control – AM loop antenna – FM wire antenna –AC power cord
Safety Information
¶ Before operating the player, check that the
operating voltage indicated on the typeplate (or the voltage indication beside the voltage selector) of your player is identical with the voltage of your local power supply. If not, please consult your dealer. The typeplate is located at the rear of your player.
¶ When the player is switched on, do not move it
around.
¶ Place the player on a solid base (e.g. a cabinet). ¶ Place the player in a location with adequate
ventilation to prevent internal heat build-up in your player. Allow at least 10 cm (4 inches) clearance from the rear and the top of the unit and 5 cm (2 inches) from the each side.
¶ Do not expose the player to excessive moisture,
rain, sand or heat sources.
¶ Under no circumstances should you repair the
player yourself, as this will invalidate the warranty!
¶ If the player is brought directly from a cold to a
warm location, or is placed in a very damp room, moisture may condense on the lens of the disc unit inside the player. Should this occur, the CD player will not operate normally. Leave the power on for about one hour with no disc in the player until normal playback is possible.
¶ Electrostatic discharge may cause unexpected
problems. See whether these problems disappear if you unplug the AC power cord and plug it in again after a few seconds.
¶ To disconnect the player from the power
supply completely, remove the AC power plug from the wall socket.
8
English
Preparations
SUBWOOFER OUT
DIGITAL OUT
HIGH POWER SUBWOOFER
S
U
B
W
O
O
F
E
R
L
E
V
E
L
C
O
N
T
R
O
L
STANDBY ON
CUT OFF FREQUENCY
60Hz 150Hz
MIN MAX
AUDIO OUT
LR
AM ANTENNA
R
+
–
L
–
+
LR
A
G
B
D
E
F
C
AC
MAINS
~
FM AERIAL
75Ω
AUX/
CDR
IN
Rear Connections
A
AM Loop Antenna Connection Connect the supplied loop antenna to the AM ANTENNA terminal. Place the AM loop antenna far away from the system and adjust its position for the best reception.
B
FM Wire Antenna Connection Connect the supplied FM wire antenna to the FM AERIAL (FM ANTENNA) 75 Ω terminal.
Adjust the position of the FM antenna for the best reception. Outdoor Antenna For better FM stereo reception, connect an outdoor FM antenna to the FM AERIAL (FM ANTENNA) 75 Ω terminal using a 75 Ω coaxial wire.
FM ANTENNA 75Ω
FM AERIAL 75Ω
OR
C
Speakers Connection
¶ Connect the right speaker to Front terminal R,
with the colored wire to + and the black wire to -.
¶ Connect the left speaker to Front terminal L,
with the colored wire to + and the black wire to -.
¶ Clip the stripped portion of the speaker wire as
shown.
unlock lock
12 mm
CAUTION: –For optimal sound performance, it is recommended to use the supplied speakers. – Do not connect more than one speaker to any one pair of +/- speaker terminal.
– Do not connect speakers with impedance lower than the speakers supplied. Please refer to SPECIFICATION section of this manual.