PROGRAMMING
You can program up to 40 tracks in any order in the memory.
1
Press PROG to create a new program.
2
Press CD and w or ∑ until you reach the desired track.
3
Press PROG to store the track.
4
Repeat steps 2-3 until all desired tracks are programmed.
● Press 7 to exit program mode without creating a program.
5
Press PLAY 3 to begin playback of the program. PLAY
PROGRAM appears on the display.
● The total playing time and the number of tracks appears each time
you program a track.
● If are track is number higher than 30 or the total playing time
exceeds 99:59, then - - : - - will appear instead of the playing time.
18 Programming Tracks
• If you press any of the DISC
DIRECT PLAY buttons, the sys-
tem temporarily ignores the pro-
grams. PROG disappears from
the display. It reappears when
playback of the selected disc is
finished.
Helpful Hint
REVIEW THE PROGRAM
1
Press 7 to stop playback.
2
Press w or ∑ to review the tracks in the Program.
CLEARING THE PROGRAM
1
Press 7 twice during playback or once when playback is
stopped. PROGRAM CLEARED appears on the display.
● The program will also clear if the disc tray opens or the system
is disconnected from the power supply.
To Next Page
Loading...
