Index-2
Index
overview of 1-3
overview of Cluster APs 1-6
placement guidelines 2-10
planning groups for 2-17
radius of coverage values 2-4
rebooting after configuration 3-40
serial port 1-4, 1-7
standard 1-3
status LEDs 1-5, 1-8
summary table worksheet 2-26
testing and inspecting 5-2
Act LED 1-5, 1-8
Add AP button 4-11
Adding an AP via Auto-Registration 4-7
Adding an AP via Manual MAC Address Input 4-10
Adding APCs to an Existing ITS 4-13
Adding APs to an Installed ITS 4-6
Adding New AP Groups to an Existing ITS Configuration 4-15
Advanced 2.4 GHz channel configuration 2-24, 2-33, 3-28
Alert Destination 2-35, 3-31
ALERTS SETTINGS tab 3-30
American Society for Healthcare Engineering (ASHE), registering with 1-15
AP Controller Name 3-15
AP group configuration worksheet 2-35
AP group name 2-35
AP groups
configuring 3-29
planning 2-17
AP Name 3-38, 4-11
AP Type 4-11
AP/SU connectors on Sync Unit 1-11
APC serial interface main menu 3-13
APC web-based management interface, connecting to 3-14
ARIB 2-33, 3-27
AS/NZ 2-33, 3-27
Asymmetrical patient room layout, providing RF coverage for 2-7
Audience for this guide
x
B
BASIC SETTINGS tab 3-29
Bluetooth device, as 2.4 GHz interference source 2-20
BOOTP/DHCP Settings 3-23
C
Cable delay switch 2-15
CABLE DELAY Switch on Sync Unit 1-12
Cable runs, planning 2-12
Carved-out areas in WMTS 1-14
To Next Page
Loading...