Philips M3921A - Troubleshooting Categories

Power-up Defaults Menu
38 Power-up Defaults Menu And Diagnostic Mode
Menu Item* Choices** Explanation
Accept Current
Settings as Power-Up
Defaults?
Yes
No
If Yes is chosen, the current monitor
settings become the power-up defaults.
Adult/Neonatal Mode
(A3 only)
Neonatal mode is not available at this time;
thus, when this item is selected, the
following pop-up message will appear:
Selection not available.
Alarm Silence Period 30 s, 60 s,
90 s, 120 s
Time is indicated in seconds. Pressing the
front-panel Alarm Silence button
temporarily silences audible alarms for the
time indicated in the Silence Period menu
item. Alarm state(s) in effect at the end of
the pre-set interval cause the audible alarm
to sound. Pressing the Alarm Silence
button a second time (while the silence
interval is still in effect) ends the interval
immediately. Silencing audible alarms
does not affect visual alarm indications.
Permanent Audible
Alarm Silent
Make Available
Deny Access
If Make Available is chosen, the
caregiver may permanently silence the
audible alarm for a particular parameter via
the Alarm/Limits Menu. Some institutions
may wish to prevent audible alarms from
being permanently silenced. If so, Deny
Access should be selected.
Alarm Suspend Make Available
Deny Access
If Make Available is chosen, the
caregiver may invoke the Alarm Suspend
Mode by pressing and holding the Alarm
Silence button for 2 seconds. Some
institutions may wish to prevent Alarm
Suspend from being invoked. If so, Deny
Access should be selected.
Auto-Set Limits Make Available
Deny Access
If Make Available is chosen, the
caregiver may invoke the Auto-Set Limits
function via the Alarm/Limits Menu. Some
institutions may wish to prevent Auto-Set
Limits from being invoked. If so, Deny
Access should be selected.
SpotCheck Mode
(A1 only)
Deny Access
Make Available
If Make Available is chosen, the
caregiver will invoke the SpotCheck Mode
as one of four choices available through
the Display icon in the Menu Frame. The
factory default is to Deny Access,
allowing only three choices available
through the Display icon in the Menu
Frame.