Disassembly Procedures (A3)
82 Chapter 6 - Disassembly Guide
Procedure to remove the switch panel:
1. The switch panel is attached with an adhesive to the front panel.
2. Carefully lift up one corner of the switch panel and peel it away from the
front panel. When the switch panel is free, feed the connector through the
slot in the front panel.
Procedure to remove the LCD:
1. Remove the six fastening screws around the periphery of the display
backplate. Retain the fastening screws for reassembly.
2. Carefully remove the metal and foil grounding tabs and washer noting
their location and orientation for reassembly. The display backplate can
now be removed.
3. Disconnect the backlight connector from the backlight inverter. The LCD
can now be lifted out of the front bezel assembly.
For reassembly, place the LCD into the backplate before seating down on
the screws. Confirm that the foil ground tab and unused white wire cable
is placed out of the way and over the taller standoff.
Foil ground tab
To Next Page
Loading...
