Initial operation 9
Preparing the remote
control
CAUTION!
The improper use of batteries can lead
to overheating, explosion, risk of fire and
injury. Leaking batteries can possibly
damage the remote control.
Never expose the remote control to
direct sunlight.
Avoid deforming, dismantling or charging
the batteries.
Avoid exposure to open fire and water.
Replace empty batteries immediately.
Remove the batteries from the remote
control if not in use for long periods of
time.
1 Open the battery compartment.
2 Insert the supplied batteries (type AAA)
with correct polarity (+/-) indicated.
3 Close the battery compartment.
• When using the remote control, point
the remote control at the rear side of the
projector where the IR sensor is located,
and make sure there is no obstacle
between the remote control and the rear
side of the projector.
Power on and setup
1 Press to turn on the projector. The LED
on the projector turns from red to green.
• To turn off the projector, press again.
The LED on the projector turns from
green to red.
• The distance between the projector and
the screen determines the actual size of
the image.
2 To adjust image focus, turn the focus knob
around the lens of the projector.
NeoPix
Start
To Next Page
Loading...
