Philips NPX230/INT - Power supply; 2 Overview; Rear view

Overview 5
Power supply
Use only a power adapter which is certified for
this product (see Technical data, page 30).
Check whether the mains voltage of the power
supply matches the mains voltage available at
the setup location. This product complies with
the voltage type specified on the product.
The power outlet shall be installed near the
product and shall be easily accessible.
CAUTION!
Always use the button to turn the
projector off.
Turn off the product and unplug from the
power outlet before cleaning the surface
(see Cleaning, page 27). Use a soft, lint-
free cloth. Never use liquid, gaseous or easily
flammable cleaners (sprays, abrasives, polishes,
alcohol). Do not allow any moisture to reach
the interior of the product.
DANGER!
Risk of eye irritation!
This product is equipped with a high
power LED (Light Emitting Diode),
which emits very bright light. Do not
look directly into the projector lens
during operation. This could cause eye
irritation or damage.
2 Overview
Rear view
abc
h
i
e
d
f
g
j
a
USB
Connect to a USB input device, USB storage
device or dongle.
b
HDMI™
Connect to an HDMI™ output port on a
playback device.
c
3.5 mm audio output; connect to external
speakers or headphones.
d
Rear IR sensor
e
• Switch the projector on or to standby
mode.
• When the projector is on, the LED lights
up in white.
• When the projector is in standby mode,
the LED lights up in red.
f
Ceiling hanging system
g
Foot pad
h
AC power jack
Connect to a supplied power cable.
i
LED light dimmer
• The dimmer is enabled only when the
projector is in standby mode.
• Tap and hold the right button for 2
seconds to turn on the light. Tap this
button to increase the brightness.
• Tap and hold the left button for 2
seconds to turn off the light. Tap this
button to decrease the brightness.
j
Air vent