5. Switching On and
Off
5.1. On or Standby
Make sure the TV is connected to the mains AC power.
Connect the supplied power cord to the AC in connector
at the back of the TV. The indicator light at the bottom of
the TV lights up.
Switch on
Press on the remote control to switch the TV on. You
can also press the small joystick key on the bottom of the
TV to switch the TV on in case you can't find the remote
control or its batteries are empty.
Reboot
Long press on the remote control for three seconds to
reboot the TV.
Switch to standby
To switch the TV to standby, press on the remote
control. You can also press the small joystick key on the
back of the TV.
In standby mode, the TV is still connected to the mains
power but consumes very little energy.
To switch off the TV completely, disconnect the power
plug.
When disconnecting the power plug, always pull the
power plug, never the cord. Ensure that you have full
access to the power plug, power cord and outlet socket
at all times.
5.2. Keys on TV
If you lost the remote control or its batteries are empty,
you can still do some basic TV operations.
To open the basic menu:
1 - With the TV switched on, press the joystick key on the
back of the TV to bring up the basic menu.
2 - Press left or right to select Volume, Channel or
Sources. Select Demo, to start a demo movie.
3 - Press up or down to adjust the volume or tune to the
next or previous channel. Press up or down to go
through the list of sources, including the tuner selection.
Press the joystick key to start the demo movie.
4 - The menu will disappear automatically.
To switch the TV on standby, select and press the
joystick key.
13
To Next Page
Loading...
Need help?
General
