Philips TAB8967 - Page 13

13 EN
Replace the Remote Control
Battery
The remote control requires AAA battery.
1 To replace the batteries, open the
battery compartment on the back of
the remote control.
2 Slide the battery door in the direction
shown by the arrow.
3 Remove the old battery, which is
located in the lid, place the new AAA
battery and pay attention to the
correct polarity (+/-).
4 Reposition the battery door and
slide it back until it clicks.
1
2x
AAA
LR03
1.5V
3
2
1
2x
3A
1.5V
2
1
Click
Click
Precautions Concerning Batteries
• When the Remote Control is not to
be used for a long time (more than a
month), remove the battery from the
Remote Control to prevent it from
leaking.
• If the batteries leak, wipe away
the leakage inside the battery
compartment and replace the
batteries with new ones.
• Do not use any batteries other than
thosespecied.
• Do not heat or disassemble batteries.
• Neverthrowtheminreorwater.
• Do not carry or store batteries with
other metallic objects. Doing so
could cause batteries to short circuit,
leak or explode.
• Never recharge a battery unless it is
conrmedtobearechargeabletype.
• Leaving a battery in an extremely
high temperature surrounding
environment that can result in
an explosion or the leakage of
ammableliquidorgas.
• A battery subjected to extremely
low air pressure that may result
in an explosion or the leakage of
ammableliquidorgas.
CAUTION - Risk of explosion
• Riskofreorexplosionifthebatteryisreplaced
by an incorrect type.
• Use consumer grade, non-rechargeable carbon-
zinc or alkaline batteries AAA type.