EN 20
Pair up with Surround R/L
Automatic Pairing
1 Plug the Soundbar and the Surround
R/L into the mains sockets and then
press on the unit or remote control
to switch the unit to ON mode. The
Surround R/L and Soundbar will
automatically pair.
» Determine the status based on
the Surround R/L indicator.
LED State Status
Fast blink Surround R/L in Pairing mode
Slow blink Pairing Failed
Constant on Connected / Pairing successful
2 Connect the Left and Right Surround
with RCA cable.
RCA cable
Tips
• Do not press Pair button on the rear of the
surround except for manual pairing.
Manual Pairing
If no audio from the Surround R/L can
be heard, manually pair up the Surround
R/L.
1 Both sound bar and wireless surround
speakers are on.
2 Press and hold (5 seconds) the Pair
button on wireless surround speaker
until the surround speakers Red LED
blink.
3 Press and hold Soundbar local keys
Play/Pause and Vol+ for 3 seconds.
4 The soundbar will discover and pair
with the surround speakers in pairing
mode.
» Main unit and surround speakers
shall discover each other and
pair, main unit display shows
“PAIRING”.
» If pairing succeeds, main unit
display shows “SURR PAIRED” for
3 seconds.
» If pairing fails, main unit display
shows “CHECK SURR” for 3
seconds. If Soundbar cannot
know which device type has
failed to pair, main unit will show
“CHECK DEVICE” for 3 seconds.
When performing manual pairing, the
soundbar must be on. Pairing can only
be done one device per time. Refer
to Wireless Subwoofer and Wireless
Surround Speakers sections for details.
To Next Page
Loading...
