Philips TAB8967 - Wi-Fi Connection Troubleshooting; Remote Control Not Working

EN 34
manual of the device on how to
enable the function.
• The device is not correctly connected.
Connect the device correctly.
• The soundbar is already connected
with another Bluetooth device.
Disconnect the connected device,
then try again.
Quality of audio play from a connected
Bluetooth device is poor.
• The Bluetooth reception is poor.
Move the device closer to the
soundbar, or remove any obstacle
between the device and the
soundbar.
Ican’tndtheBluetoothnameofthis
unit on my Bluetooth device
• Ensure the Bluetooth function is
activated on your Bluetooth device.
• Re-pair the unit with your Bluetooth
device.
Wi-Fi
Wi-Fi Connection cannot be established.
• Check the availability of WLAN
network on the router.
• Place the Wi-Fi router closer to the
unit.
• Make sure the password is correct.
• Check the WLAN function or reboot
the modem and Wi-Fi router.
Dolby Atmos
Cannot achieve outstanding Dolby Atmos
eects.
• For non-HDMI connections (such as
use of USB, Bluetooth, OPTICAL or
AUDIO IN), limited height surround
eectsaregenerated.Seethesection
of ‘Dolby Atmos’ about how to
achievebestDolbyAtmoseects.
Remote control does not work
• Before you press any playback
controlbutton,rstselectthecorrect
source.
• Reduce the distance between the
remote control and the unit.
• Insert the battery with its polarities
(+/-) aligned as indicated.
• Replace the battery.
• Aim the remote control directly at
the sensor on the front of the unit.
Thisisa15minspowero
function, one of the ERPII
standard requirement for saving
power
• When the unit’s external input
signal level is too low, the unit will
beturnedoautomaticallyin15
minutes. Please increase the volume
level of your external device.
The subwoofer is idle or the
indicator of subwoofer do not
light up
• Please unplug power cord from the
mains sockect, and plug it in again
after 3 minutes.