Philips VoiceTracer DVT2010 - Enabling;Disabling Voice-Activated Recording; Setting Auto Divide

31
Settings
Table of contents
13
Set the time as described in (see also chapter 9.3.1 Set date & time,
page 34).
14
Press the record key, g, to confirm.
15
Press the stop key j.
16
Press + / – to select the Duration function to set the recording
duration.
17
Press the record key, g, to confirm.
18
Press + / – to set the required recording duration. Press no limit
for unlimited recording.
19
Press the record key, g, to confirm.
20
Press + / – to select the Record source function to set the sound
source.
21
Press the record key, g, to confirm.
22
Press + / – to select if the device should record from an internal
microphone or an external source.
23
Press the record key, g, to confirm.
24
Press the stop key j.
X The device will start recording at a specified time.
Tip
• Press the j key to cancel the operation without saving and return
to the stop mode.
9.1.6 Enabling/disabling voice-activated recording
If voice-activated recording is enabled, recording session will start
when you begin speaking. When you stop speaking, the device will
automatically pause recording after three seconds of silence, and
resume only when you begin speaking again.
Use the voice activation level to set the volume at which the device
should begin recording.
1
In stop mode (start-up screen), press MENU.
2
Press the h / b key to select the record settings menu Ó.
3
Press + / – to select the Voice Activation function.
4
Press the record key, g, to confirm.
5
Press + / – to select the On function.
6
Press the record key, g, to confirm.
X If this feature is on, the Š symbol is displayed.
7
Press + / – to select the Off function to turn o voice-activated
recording.