38 Service
Table of contents
Tip
• Press the j key to cancel the operation without saving and return
to the stop mode.
10.1.3 Device reset
This function is used to return all settings to the factory defaults.
Recordings and files are not deleted.
1
In stop mode (start-up screen), press MENU.
2
Press h / b to select the device settings menu Õ.
3
Press + / – to select the Reset default function.
4
Press the record key, g, to confirm.
5
Use + / – OK to select.
6
Press the record key, g, to confirm.
X All device settings will be reset to the factory defaults. You
must reset the display language, date and time (see also chapter 4.3
Initial installation process, page 15).
10.2 Replacing batteries or rechargeable batteries
Caution
• Do not remove batteries or rechargeable batteries from the device
while it is recording. If you do this, data may be damaged or lost.
Device malfunctions may also occur.
When the batteries are nearly empty, the battery indicator blinks; you
should replace them.
Proceed as described in 4.1 Inserting the batteries.
Note
• If it takes longer than 2 minutes to replace the batteries, you may
have to reset the time.
• Never try to recharge alkaline or non-rechargeable batteries.
• Batteries and rechargeable batteries contain substances that
may pollute the environment. Used batteries and rechargeable
batteries should be disposed of at an ocial collection point.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
