Phonak ComPilot User Manual

59
1. Ensure that the ComPilot is turned ON and the
neckloop is plugged in and worn correctly.
2. Locate the Bluetooth section in your phone menu
and select list of “Paired devices”.
3. Locate and highlight your ComPilot and select
“Connect”.
4. Conrmation of successful connection is indicated
on the ComPilot by the Audio indicator blinking
blue. Additionally a headset symbol ( ) may appear
on the main screen of your phone.
I The connection between your ComPilot and your
phone will be maintained as long as the two devices
remain on and are within range of each other. If
either device is switched o or moves out of range,
you may need to repeat the connection procedure.
I Some phones may perform the connection procedure
automatically after pairing. We recommend selecting
“Yes” when prompted to allow this device to connect
automatically once the pairing is completed.
Please consult your phone‘s user guide in the case
where a manual connection is necessary.

Phonak ComPilot Specifications

General

Bluetooth	Yes
Battery Type	Rechargeable
Streaming Time	Up to 8 hours
Remote Control	Yes
Microphone	Yes
Neckloop	Yes
Operating Range	Up to 10 meters
Audio Input	3.5mm audio jack
Compatibility	Phonak hearing aids
Bluetooth Version	Bluetooth 2.1 + EDR
Supported Audio Sources	Bluetooth enabled devices, FM
Charging Time	Approximately 3 hours