Phonak ComPilot User Manual

61
5. Your ComPilot will remain in the pairing mode for
two minutes or until the pairing is completed.
6. If a passcode is required, enter “0000” (four zeros).
After pairing, wait until the devices have completed
connection.
Confirmation of successful connection is indicated
on the ComPilot by the Audio indicator shortly
blinking blue. A double-blink indicates that two
devices are connected to ComPilot.
Deleting the pairing of Bluetooth devices
If you encounter issues with one of the paired devices,
or if a device stops connecting to your ComPilot,
you may consider deleting the pairing of devices to
the ComPilot.
1. Turn ON your ComPilot.
2. Press and hold the ( )- and ( ) buttons for
10 seconds until the blue rapid blinking Audio
indicator stops.

Phonak ComPilot Specifications

General

Bluetooth	Yes
Battery Type	Rechargeable
Streaming Time	Up to 8 hours
Remote Control	Yes
Microphone	Yes
Neckloop	Yes
Operating Range	Up to 10 meters
Audio Input	3.5mm audio jack
Compatibility	Phonak hearing aids
Bluetooth Version	Bluetooth 2.1 + EDR
Supported Audio Sources	Bluetooth enabled devices, FM
Charging Time	Approximately 3 hours